Is Smart Device:no is_customized:Yes Maximum Current:80A Model Number:MPPT Application:Thermal Controller,Charger Controller,Solar System Controller Origin:Mainland China Certification:CE Solar Charge Controller MPPT 30A 40A 50A 60A 80A 100A LCD Display 12V 24V AUTO Dual USB Solar Charge And Discharge Controller Features                                                         1. Industrial-grade master chip, 16 AD sampling accuracy, temperature, charging current, discharge current accurate real-time display, power generation at a glance. 2. Automatic focusing MPPT tracking charging, high charging efficiency, non-stop detection during charging, bidirectional focusing tracking. 3. Acomplete three-phase charge management, effectively protect the battery, the battery is more durable. 4. Large-screen LCD display, adjustable charging and discharging parameters. UItra-wide charge and discharge adjustable, as long as you understand the characteristics of the battery set its corresponding charging parameters, you can charge a battery. When the output is off, the time can be adjusted, which is more convenient. (on the market, there is no point adjustment) 5. Bidirectional MoS tube anti-backflow circuit, high-power charging mode, ultra-low heat. 6. Built-in overheating, overcurrent short circuit, open circuit protection, reverse connection protection,when the fault is eliminated, the controller automatically recovers, does not damage the device. 7. R5. 0 solar charging DC plug, R5. 0 DC lamp output DC plug, convenient connection. Specifications                                                    1. Rated voltage: 12/24V 2. Rated current: 30A/40A/50A/60A/80A/100A 3. Max. PV voltage: 60V 4. Max. PV input power: 1300W(12V) / 2600W(24V) Package includeskag                                       e Includes:                                   1 x Solar Panels Battery Charge Controller 1 x User Manual Note :                                                             1: This controller is 12V/24V automatic adaptation. When installing for the first time, please make sure that the battery has enough voltage for the controller. 2 : Install the controller as close to the battery as possible to avoid the voltage drop caused by the excessive length of the wire, which affects the normal voltage judgment. 3: The controller can be used for lead-acid batteries and lithium batteries. If you charge a lithium battery, you must set the charging parameters after connecting to the power source. Please refer to the manual for details. 4: The controller can only use photovoltaic panels as the charging source, do not use DC or other power sources as the charging source. 5 : When the controller is running, it will heat up. Please be careful to install the controller on a flat, well-ventilated surface.